A951 20 532081 - RevA
1
2
3
3
4
4
11
2.5
Translation of the original instructions
ENGLISH
5.3 SLIDING ARM
Carry out the installation procedure with the door
closed.
!
Be careful when working in the area between the
sliding and the guide because of the following risks:
- Finger crushing / shearing hazard.
- Hooking / entanglement of clothing, tools, equip-
ment.
1. Assemble the transmission arm as shown in 11:
- Slide the sliding (1) into the guide.
- Insert the limit switch block (2) into the guide.
Once fixed, the block will determine the maximum
opening position of the door. The position in
which it will be fixed will be determined later in this
installation procedure.
- Install the side covers (3) at the ends of the guide
and fasten them using the grub screw.
The protruding edge (4) must face outwards with
respect to the side that is attached to the door.
To Next Page
Loading...
