Programming the System Settings
MP-70/50 • MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13 145
SETTINGS FOR BASEBALL BOARD TYPES 34, 35 & 39
To display pitch speed on your scoreboard, you will need a Jug’s Speed gun
(model HTRCR-1K) and a Jug’s cable (model R7010) or a Stalker Pro II Speed
Sensor. Your MP-70 control will also need to be enabled for this feature. This is
done at the factory. Consult your Fair-Play dealer for details.
Press YES if you want to enable pitch speed.
Press NO if you do not want to enable pitch
speed.
SETTINGS FOR BASEBALL BOARD TYPES 34 & 35
If you answered YES to PITCH SPEED prompt, then this will trigger the 2
DIGIT CLK prompt.
Press YES if you want to enable 2 Digit
Clock.
Press NO if you do not want to enable 2 Digit
Clock.
MP-70 AND MP-69 DATA OUTPUTS
Your Fair-Play scoreboard requires data in one of two
formats: MP-70 or MP-69.
MP-69 is a data format developed in 1984, and still in use in some
incandescent-light scoreboards.
MP-70 is the current data format and was
developed in 1998.
Note: The tables listed under BOARDS SUPPORTED
on page 147 indicate which data format your
scoreboard model requires.
Note: Although Trans-Lux sells an MP-70 control, it is important to note that in
this instance, “MP-70” also refers to a protocol used by your controller to
communicate with the scoreboard. Hence, the MP-30 control uses the
MP-69 or the MP-70 data transmission method to communicate with your
scoreboard.
SYSTEM SETTINGS
PITCH SPEED? Y/N
SYSTEM SETTINGS
2 DIGIT CLK? Y/N
SYSTEM SETTINGS
CONN3&4,MP69?Y/N
SYSTEM SETTINGS
CONN.2,MP69? Y/N
SYSTEM SETTINGS
CONN.1,MP69? Y/N
To Next Page
Loading...