Hardware
12 MP-70/50 • MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13
TURNING ON THE MP-70/50
Before turning on the MP-70/50, verify that it is connected to a standard 120-volt
grounded outlet. See IMPORTANT PRECAUTIONS on page 8.
The controller’s ON/OFF switch is located at the rear of the console. Move this
switch to the ON position. The MP-70/50 displays the
start-up message. (The version number may be
different from the one shown here.)
PROGRAMMING THE MP-70/50
The MP-70/50 control’s system settings must be properly programmed
(configured) or it will not operate correctly!
Before turning on your control, carefully read and understand the instructions in
PROGRAMMING THE SYSTEM SETTINGS on page 142 and in SELECTING AND
CHANGING SPORTS on page 151.
- TRANS-LUX -
MP-70, VER.X.XX
To Next Page
Loading...
