Selecting and Changing Sports
MP-70/50 • MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13 161
SAVING A CONFIGURATION
Before returning to normal operation you will be asked to enter a name for the
configuration you just entered. The name can be up to 16 characters long.
1. Respond YES to QUIT. You will see a portion of the alphabet on the
top line of the LCD. The bottom line will read, ENT.CONFIG.NAME.
2. Use the 4 (back) and 6 (forward) keys to move the cursor through
the alphabet on the top line until it is under the letter you want.
3. To select a specific letter, press the 5 (next) key.
4. Continue entering letters.
5. Press ENTER when name is complete.
The MP-70/50 control will hold up to six different configurations. (See
CONFIGURATIONS on page 163 to learn how to load a configuration.) If all six
locations are full, you will be asked if you would like to overwrite one of the
existing configurations. If you respond YES , you can then select the one you
want to replace.
To save and use a configuration without naming it, press and hold
the SHIFT key and press CLR/ESC . The control will be set for the
configuration just entered, but the configuration will not be available on the recall
list.
Always reset the control for a new game after changing any of the SYSTEM
SETTINGS or CHANGE SPORT settings. Follow instructions under NEW GAME
on page 20.
To Next Page
Loading...
