Segment Timer Operation
MP-70/50 • MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13 165
SEGMENT TIMER OPERATION
PURPOSE OF THE SEGMENT TIMER
When you want to put your team through a practice drill you can use the
Segment Timer feature to keep track of those drills, and any breaks in between.
You can program times for both training intervals, called segments, and breaks. If
you desire, the MP-70/50 can run up to 99 different segments, and a
corresponding number of breaks.
Note: Scoreboard type 32 does not currently support the Segment Timer
feature.
If you wish to use the Segment Timer and are running baseball, and you
are using Scoreboard type 39,
• Do not select At-Bat when you are changing sports (See INDICATING the
team and player at bat on page 75 of the Baseball chapter, and see
SETTINGS FOR BASEBALL BOARD TYPES 34, 35 & 39 on page 145 in the
Systems Settings chapter).
• Do not select Pitch Speed (See SETTINGS FOR BASEBALL BOARD
TYPES 34 & 35 on page 145) in Systems Settings.
PROGRAM MODE FOR SEGMENT TIMER
To program the Segment Timer, press down
the SHIFT and 2 keys together while turning on the
MP-70/50. You will see a screen display on the LCD,
similar to the one shown below.
Use the numeric keys 0-9 to enter your selected times
for segments and breaks. The first two digits signify
minutes, and the remaining two digits signify seconds.
Press ENTER to set the time and automatically
advance to the corresponding break time entry screen, an example of which is
shown below.
To increase one numeric increment of either Break Times or Segment
Times, press +1 .
Program Segments
SEG05 TIME 00:00
Program Segments
BRK02 TIME 14:00
To Next Page
Loading...