Baseball
MP-70/50 • MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13 71
SPORT-SPECIFIC SETTINGS FOR BASEBALL
When you select baseball, the MP-70/50 offers the sport-specific settings
discussed below. When you adjust these settings the MP-70/50 stores your
selections in permanent memory. Your settings become active each time you
select baseball in the future.
SINGLE-PRESS BALLS, STRIKES, OUTS
This feature allows you to increase the ball, strike and
out values with a single press of the corresponding key.
If you press NO at the 1 PRESS BSO prompt, you
must press +1 or -1 after pressing BALL , STRIKE or OUT .
AUTOMATIC SCORE TOTALING
If board types 34, 35 or 38 were selected in the
SYSTEM SETTINGS level of programming, the prompt
AUTO SC.TOTAL? will appear. Press YES if you
want the total runs to automatically increase when the
score by inning increases or NO if you prefer to manually track the total runs.
Note: Some baseball scoreboards do not offer full game clock functionality. Your
MP-70/50 will only give you prompts for the functions your scoreboard
type offers. This qualification applies to the following six items.
COUNTDOWN CLOCK
Press YES if you want the clock to count down
or NO if you want the clock to count up.
AUTO HORN
If you press YES to select auto horn, this mode is
active each time you select baseball as the sport. You
can still use the AUTO HORN key to turn this feature on
and off as instructed at SOUNDING THE HORN on page 16.
- CHANGE SPORT -
1 PRESS BSO? Y/N
- CHANGE SPORT -
AUTO SC.TOTAL? Y
- CHANGE SPORT -
COUNT DN.CLK?Y/N
- CHANGE SPORT -
AUTO HORN? Y/N
To Next Page
Loading...
