Common Functions
MP-70/50 • MP-72/52 • MP-73/53 • PN 98-0002-29 • REV 1709.13 17
For Normal Default Timer operation:
1. Turn on the TIME IN switch.
2. Press and hold down the RESET button to reset the shot timer.
3. Release the RESET button to start the shot timer.
For NCAA Football 25 Sec Timer operation:
1. Turn off the TIME IN switch.
2. Press twice on the RESET button. The display should show 25
seconds.
3. Turn on the TIME IN switch to start timer countdown.
Note: The 25 second timer feature is only available on football and versions
V2.23d and above only. It can be used when a media timeout is called
during a televised NCAA football game.
For NCAA Basketball 15 Sec Timer operation:
1. Turn off the TIME IN switch.
2. Press twice on the RESET button. The display should show 15
seconds.
3. Turn on the TIME IN switch to start timer countdown.
Note: The 15 second timer feature is only available on basketball and version
V2.26 and above only. It is intended for use when there is an intentionally
kicked or fisted ball with 14 seconds or less on the shot/field timer.
To set a different timer value from the default timer settings:
1. Turn off the TIME IN switch.
2. On the MP-70 keypad, press SET TIMER/T.O.D.
3. On the MP-70 numeric keypad, enter a two-digit time and then
press ENTER .
4. Turn on the TIME IN switch to start the timer countdown.
Note: The preceding steps can change the reset time only for a single reset
event and does not change the default timer setting held in permanent
memory. To change the default setting, refer to the sport-specific setting
for the appropriate sport.
To Next Page
Loading...
