3) The other device calls the door phone, enters the corresponding remote authentication code,
and opens the door after timeout or the password check length is reached (the authentication
code shall be configured in the access list, and the remote telephone opening shall be enabled).
4) Open the door by swiping the RFID card, which supports IC card and ID card.
5) Indoor door opening, the door can be opened through the indoor door button when the door
phone is in any state.
6) Enter the position speed dial + authentication code to open the door, and directly enter this
authentication code to open the door in standby mode. Please refer to the access list Settings
for details.
7) super administrator card and super administrator password to open the door, in the case of
door phone software exception, can open the door through the super administrator card and
super administrator password (super administrator password is only limited to the device with a
keyboard).
8) Active URL control command opens the door
The open URL is http://user:pwd@host/cgi-bin/ConfigManApp.com?Key = F_LOCK & code =
openCode
A. user and PWD are user names and passwords for logging into the web
B. openCode is the remote door opening password, and the default is *
Example: http://admin:admin@172.18.3.25/cgi-bin/ConfigManApp.com?Key = *
Access code input correct play long sound prompt access and remote users, input error through
the low frequency short sound prompt.
Password input is prompted by high frequency long sound successful, input error is prompted
by high frequency short sound.
When the door lock is opened, it will be prompted by playing the long sound..
To Next Page
Loading...
Need help?
General
