Syslog：When enabled, set the syslog software address, and log information of the device will
be recorded in the syslog software during operation. If there is any problem, log information can
be analyzed by Fanvil technical support.
Auto Reboot Setting:
Reboot Mode:
Disable：It will not restart at set time after disabled
Fixed Time：In the range of 0~24 (h), restart will be conducted at the setting point every day
after the setting is completed
Uptime：Set the maximum length to 3 bits and restart at run time
For other details, please refer to 10 trouble shooting
9.9 Network >> Basic
This page allows users to configure network connection types and parameters.
Figure 20 - Network Basic Setting
Table 9 - Network Basic Setting
The current IP address of the equipment
To Next Page
Loading...
Need help?
General
