FIRST START-UP
CARD G / FIT 18 V 6.15 E / April 2010
9.6 DATA COMMUNICATION
The SUB-D plug (3.10) on the plug panel can be used for different kinds of communication with
external devices and with the production machine.
9.7 FIRST START UP
Only qualified personnel are permitted to deal with CARD G FIT units.
It is strongly recommended to read this manual before attempting to start up
the CARD G FIT unit.
It is strongly recommended to check proper set up and installation of the unit
and all components is completed before attempting to start up the CARD G FIT
unit.
It is important to double check that the electrical power supply matches the
data on the name plate of the unit and that the main compressed air supply to
the CARD G FIT unit matches the required specification.
Contact and/or its representative for any question regarding the
set up and the installation before start up.
The CARD G FIT unit may be started up by qualified personnel after insuring following points:
Make sure that the first set up and the installation are properly done.
Make sure that all mechanical accessories (flange, loading unit …) are mounted
properly and securely.
Make sure that the exhaust air filter is mounted on the outside of the lid of the unit
(or on the loading unit).
Make sure that all electrical connections to the loading device are established (if
controlled by the CARD G FIT).
Make sure that the compressed air connections to the loading device (if used) are
established.
Make sure that the power supply cord is attached to the unit and the electrical
power supply matches the data on the name plate.
Make sure that the main compressed air supply is connected and released.
To Next Page
Loading...