FarragTech CARD G - 13 Data Input

DATA INPUT
CARD G / FIT 32 V 6.15 E / April 2010
13. DATA INPUT
The method of data input has been changed compared to the previous version of the FIT-
controller. The EDITOR SCREEN must be retrieved first, and then the required value entered and
confirmed to change a parameter.
Using the key clears wrongly entered values in the EDITOR SCREEN.
The lower part of the EDITOR SCREEN informs about the permitted range of values being entered by
the operator. If a wrong value is entered, the operator will be pointed out by a red blinking
maximum or minimum value.
The wrong value must be cleared with the key before a new value can be entered.