Feig Electronic TST FUF2-C - Page 8

TST
Assembly instructions
FUF2 / FU3F-A/-C/-F
FEIG ELECTRONIC GmbH
Page 8 of 114
TST_FUxF-A-C-F_Montageanleitung_EN_15
7 General operating instructions to set parameters 67
7.1 Open the parameter operation mode ...................................................................... 67
7.2 Editing a selected parameter ................................................................................... 68
7.3 Exit parameter operation mode ............................................................................... 68
7.4 Execute a reset ......................................................................................................... 69
7.5 Entry into the extended parameter configuration mode ........................................ 69
8 Basic settings 70
8.1 Automatic query of basic data ................................................................................. 70
9 Commissioning 71
9.1 …with absolute encoder or incremental encoder .................................................. 72
9.2 … with mechanical limit switches ........................................................................... 73
9.3 … with light curtain TST LGB .................................................................................. 74
9.4 New request for teach-in of the end positions ........................................................ 76
9.5 Boost / increase in performance for low speeds .................................................... 76
10 Movement optimisation for the door 77
10.1 Opening of the door.................................................................................................. 77
10.2 Closing of the door ................................................................................................... 78
10.3 Pre-limit switch setting ............................................................................................. 79
10.4 Ramp configuration .................................................................................................. 79
10.5 Correction of the final positions .............................................................................. 80
11 Functions 80
12 Messages 81
12.1 Error messages ......................................................................................................... 81
12.2 Information messages .............................................................................................. 98
13 General messages 101
14 Specifications 106
15 Standards and directives 112