13
Hall in Tirol, 1.2.2018
Dust Extractor
RL 250 / RL 300 / RL 350
3 Declaration of Conformity
This EC Declaration of Conformity is valid only if the CE label has been affixed to the machine.
Modifying or altering the machine without the express written agreement of the manufacturer shall render the war-
ranty null and void.
The signatory of this statement is the appointed agent for
the compilation of the technical information
Johann Felder, Managing Director FELDER KG
KR-FELDER-STR.1 • A-6060 Hall in Tirol
We hereby declare that the machine indicated below, which corresponds to the design and construction of the model
we placed on the market, conforms with the health and safety requirements as stated by the EC.
The compact dust extractor was built according to the inspection standards of the GS-HO-07 certificate (from january
2010) and was inspected according to these inspection standards by the German wood institute for statutory accident
insurance and prevention (Holz-Berufsgenossenschaft), Vollmoellerstrasse 11, 70563 Stuttgart, Germany.
The dust extractor is thus appropriate to extract and to separate dry (wood moisture < 30%) wood dust and shavings,
whereby the residual dust contents level of 3 “H3”, 0.1 mg/m³ will be adhered to.
Explanation to guideline ATEX 2014/34/EU:
On the basis of safety this machine is NOT DESIGNED and should not be used in explosion-proof areas.
There will be combustible dusts inside the dirty gas area of the dust extractor.
Due to the ignition sources-free construction the danger of explosion will be prevented.
The limited geometrical design will avoid the remaining risk of aspirated sparks.
The machine casings of RL 250, RL 300 and RL 350 are additionally designed in pressure proof quality.
Declaration of Conformity
Manufacturer:
Felder KG
KR-FELDER-STR.1
A-6060 Hall in Tirol
Product designation:
Clean-Air Dust Extractor
Make:
FELDER
Model designation:
RL 250 / RL 300 / RL 350
The following EC guidelines were applied:
2006/42/EG 2014/29/EU
2014/35/EU prEN 16770
2014/30/EU
The prototype test was carried out by:
DGUV Test
Prüf- und Zertifizierungsstelle Holz
Fachbereich Holz und Metall
Vollmoellerstraße 11
D-70563 Stuttgart
NB 0392
To Next Page
Loading...
