Felder RL 250 - Dust Extractor Operation

29
20 m/sV<
Auto
A
CH
TU
N
G
! H
auptschalter
trennt M
asch
ine nicht vom
D
ruckluftnetz !
A
TTEN
TIO
N
! M
ain sw
itch does not
disconnect pneum
atic pow
er supply !
20 m/sV<
Auto
A
C
HTU
N
G
! H
auptschalter
trennt M
asch
ine nicht vo
m
D
rucklu
ftnetz !
A
TTEN
TIO
N
! M
ain sw
itch do
es not
disco
nnect pneum
atic pow
er supply !
!
"
#
!
Dust Extractor
RL 250 / RL 300 / RL 350
Fig. 6-11: Direction of the Motor rotatation
6.7 Dust extractor operation
Fig. 6-10: Connection tube
!Coil hose
"Metal spiral casing
The device is, from the safety point of view, designed to absorb from:
Woodworking machinery with an extraction connection smaller or equal:
RL 250: 250 mm / RL 300: 300 mm / RL 350: 350 mm
Attention! If the direction of rotation of the drive motor is incorrect, for example as a result of the incorrect
polarity, switch the machine off immediately, as the resulting suction output is not sufficient, and it pre-
vents the machine from heating up (prohibited).
#Phase inverter (Option)
Attention! Risk of material damage!
Only operate the machine in ambient temperatures
from +10° to +40° C. If the instructions are not followed, damage may occur during storage.
Setup and installation
All protective covers must be properly attached before
starting the unit.
Use a piece of so-called ”coil hose” to connect your dust
collector to the dust collecting system to avoid forwarding
vibrations to the system.
You must now strip the metal spiral approx. 10 cm on
both sides, mount the hose, with a pipe clamp, onto the
wall of the extractor connector or tubing.
•
The dust collector should be positioned as close as
possible to the woodworking machine.
• It must stand on a level surface.
Check the direction of rotation before switching the machine
on!
• Plug the device into the electric mains supply; switch on
briefly.
• Direction of the Motor rotatation: Clockwise
• To change the direction of rotation, (if vacuum output is
very low) turn the phase inverter with a screwdriver by
180°.
(see FELDER-catalogue)
• After connecting the extractor hose to the woodworking
machine, first switch the dust collector on, then the
woodworking machine.
• Reverse this sequence when switching the machines off.
Attention!
Do not change the location of the unit during operation.
Wheel lock: press in and lock