30
!
Dust Extractor
RL 250 / RL 300 / RL 350
7 Operation
7.1 Safety instructions
Before starting work:
• Before commencing any work with the machine,
inspect it to ensure that it is complete and in
technically good condition.
• Ensure that there is sufficient space to work around
the machine.
• Keep the work area orderly and clean.
Components and tools that are not put in their correct
place or put away may be the cause of accidents!
• Do not place any objects or tools onto the machine.
• Ensure that all safety devices have been installed
properly.
• Check that the extraction hoses or extraction pipes
are correctly installed.
• Check that unused extraction connections are closed
properly.
• Visual check for leaks around filter (dust ejected from
the unit cover). Renew the damaged
filter immediately.
• Check that the chip bags are closed and are not
damaged. Renew the damaged chip bags
immediately.
• The machine has to be switched off when carrying
out any work on the machine.
• Before switching on the machine, always check to
make sure that there are no other persons in the
immediate vicinity of the machine.
Warning! Risk of injury!
Improper operation may lead to severe physical injury or material damage.
For this reason, this work may only be carried out by authorised, trained personnel who are familiar
with how to operate the machine and in strict observance of all safety instructions.
Attention! Risk of material damage!
Only operate the machine in ambient temperatures
from +10° to +40° C.
If the instructions are not followed, damage may occur during storage.
When working on or with the machine, the following
must always be worn by personnel:
• Sturdy, tight-fitting clothing (tear-resistant, no wide
sleeves).
• Protective footwear– To protect the feet from heavy
falling objects and prevent sliding on slippery floors.
• Hearing protection– pour éviter des traumatismes
auditifs.
During operation:
• If a fault occurs, switch the machine off and secure it
against being switched on again. Wait until the fan
wheel has stopped.
• If a power failure occurs, switch off the main switch
(Position „0“). This avoids the machine restarting
once the power is back on.
• Do not switch off, circumvent or decommission
protective and safety devices during operation.
• Ensure that no foreign objects (e.g. nails, screws) are
vacuumed.
• Do not change the location of the unit during
operation.
Operation
Warning! Danger of fire!
Improper operation can lead to a fire breaking out.
Therefore:
• Only vacuum sawdust and woodshavings.
• Do not vacuum spark-generating objects (e.g. nails, screws etc.).
• Do not vacuum any inflammable waste. (e.g. cigarette ends, flying sparks, etc.)
To Next Page
Loading...
