Felder RL 250 - Technical Specifications; Dimensions and Weight; Important Information

14
2257
1309,6567,25
1134,5
1149,3
1163,006
2636,5
2272,8
725
ø - mm
A
A1
A2
C
C2
1310
ø - mm
min. 200 mm
Option: 245 mm
570
B
B2
Dust Extractor
RL 250 / RL 300 / RL 350
Basic extractor
Total length (A) 2275 mm
Total length (A1) 2640 mm
Overall width (B) 1140 mm
Total height (C) 2260 mm
Weight RL 250 / RL 300 785 kg
Weight RL 350 825 kg
Chip container
Total length (A2) 1165 mm
Overall width (B2) 1150 mm
Total height (C2) 725 mm
Bag volume 2 x 250 litres
Motor power see data plate
RL 250
Filter surface 50 m²
Air-to-cloth ratio
(for nominal air flow rate) 71 m³/m²xh
Extractor supports- ø 250 mm
RL 300
Filter surface 50 m²
Air-to-cloth ratio
(for nominal air flow rate) 102 m³/m²xh
Extractor supports- ø 300 mm
RL 350
Filter surface 71,3 m²
Air-to-cloth ratio
(for nominal air flow rate) 98 m³/m²xh
Extractor supports- ø 350 mm
RL 250 / RL 300 / RL 350
Pneumatic connection 7–12 bar
Air consumption 40 Nl/min
Polyester drum filter Category „M“
Dust emission quality (mg/m³) <0,1*
Noise emission max. 75 dB (A)**
4.1 Dimensions and weight
Fig. 4-1: Overview
4 Technical specifications
The dust inspection applies to beech wood dust, with the fol-
lowing specifications:
• Approx. median value 100 µm , 20 µm ≤ d
90
≤ 300 µm
• Wood moisture 8 % ± 2 %
• The metered beech wood dust concentration amounts to 5
g/m³ of air.
4.1.2 Important information
Specifications
* H3-certification with 0.1mg/m³ passed well within tolerance,
(wood dust)
** An allowance must be made to compensate for tolerances
with the specified emission values. K= 4 dB (A).
The measurement results are in accordence to prEN 16770
(See chapter entitled > Noise emission< )