Fav 900
Engine / Injection Pump
Checking Start of Delivery VP 44
E
Testing
Fav 900 Chassis Number 23/3001 and up
01/2000
2710 000003
E
b
3/7
Capitel Docu-No.
Index
Date Version
Page
Checking Start of Delivery VP 44
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Turn crankshaft back toward TDP until
displacement (X . XX) which is indicated on the
injection pump will be reached .
E.g.: Indicated Value on Injection Pump: 0.79
Consequently: Adjust TDP to reach 0,79 mm on
dial gauge
Note:
Scanning head of dial gauge runs into slanted
surface of the control shaft.
Do not turn crankshaft any further , risk of
shearing the scanning head of the dial gauge.
PMTAB_Picture
TDP is correctly set when flywheel is in TDP
position (± 0,5 °).
Note:
The effective start of delivery, approx. 6° vor
O.T. (under full load) will be set automatically
by the injection controller .
If the flywheel is in wrong position, start of delivery
will not be correct ( adjust start of delivery ).
PMTAB_Picture
Adjusting start of delivery
Remove dial gauge and adaptor.
PMTAB_Picture
Remove cover (M8)
To Next Page
Loading...