FENDT MAN D 0836 LE - Removing and Refitting Valve Guides

Fav 900
Engine / Cylinder head
Removing and refitting valve guides.
G
Repair
Fav 900 chassis number 23/3001 and up
19.02.2001
2010 000009
G
a
1/1
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting valve guides.
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Removing the valve guide
Removing and refitting the cylinder head.
Removing and refitting the valves.
Position cylinder head on a press with the
combustion chamber side facing upwards. Use a
mandrel to press out the valve guide.
PMTAB_Picture
Refitting the valve guide
Lubricate new valve guides and using a mandrel
and spacer sleeve, press in form the rocker arm
side.
PMTAB_Picture
Valve guides differ in length only.
1 Exhaust = shorter guide
2 Intake = longer guide
3 Press-in depth (see Servicing Data)
Press-in depth is governed by the spacer sleeve.
Note:
After replacing the valve guides it is necessary
to re-grind the valve seats ( see Servicing Data
and instructions by the manufacturer of the
valve lathe used in your workshop).