Fav 900
Engine / Short block
Removing and refitting camshaft
G
Repair
Fav 900 chassis number 23/3001and up
20.2.2001
2210 000007
G
a
1/2
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting camshaft
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Removing camshaft
● Remove oil pan
● Remove timing case cover, idler gear and
camshaft gear.
● Remove flywheel housing
● Remove rocker arm assembly and pushrods.
Unscrew axial stop screws and remove axial stop.
Note:
Following photographs show the driving gears
and timig case removed. The camshaft can be
replaced without removing these parts.
PMTAB_Picture
Put engine upside down in order to have the
pushrods sliding toward the cylinder head in such
a manner that they will not disturb the removing
operation of the camshaft!
With a special mandrel push out camshaft from
the timing case end, at the same time guiding it at
the flywheel end.
PMTAB_Picture
Check tappets, replace if necessary.
PMTAB_Picture
Replacing camshaft bearings
Using a mandrel, drive out camshaft bushes.
Note:
Crankshaft must be removed.
Note:
On the new bushes the notch must be facing
the fan end, and the oil channels should be
aligned with those in the timing case.
To Next Page
Loading...