Fav 900
Engine / Injection Pump
Checking Start of Delivery VP 44
E
Testing
Fav 900 Chassis Number 23/3001 and up
01/2000
2710 000003
E
b
5/7
Capitel Docu-No.
Index
Date Version
Page
Checking Start of Delivery VP 44
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Turn crank shaft back by at least 20° before TDP
and then set dial gauge with adaptor
(X 899.980.245.000) into the TDP measuring
hole.
Note:
Use dial gauge with ball tip R=1 mm (0.039").
PMTAB_Picture
Set dial gauge into "0" display position.
PMTAB_Picture
Turn crankshaft back toward TDP until
displacement (X . XX) which is indicated on the
injection pump will be reached .
E.g. : Indicated value on injection pump: 0.79
Consequently : Adjust TDP to reach 0,79 mm on
dial gauge
Note:
Scanning head of dial gauge runs into slanted
surface of the control shaft.
Do not turn crankshaft any further , risk of
shearing the scanning head of the dial gauge.
PMTAB_Picture
Start of Delivery point is wrong!
Requested value start of delivery: TDP (+/- 0,5°)
To Next Page
Loading...