FENDT MAN D 0836 LE - Replacing Crankshaft Axial Stop; Removing and Refitting the Timing Case

Fav 900
Engine / Short block
Removing and refitting the timing case.
G
Repair
Fav 900 chassis number 23/3001and up
20.2.2001
2210 000006
G
a
2/4
Capitel Docu-No.
Index
Date Version
Page
Removing and refitting the timing case.
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PM-Picturemodule
PMTAB_Picture
Replacing crankshaft axial stop
If necessary, replace cranshaft axial stop (thrust
washer).
PMTAB_Picture
Removing timing case
Unscrew and remove screws (SW13) between oil
pan and timing case.
PMTAB_Picture
Unscrew and remove all other screws.
Remove timing case.
PMTAB_Picture
Refitting timing case
Fit new gaskets to crankshaft housing.
Install timing case
Note:
Replacement studs of the injection pump must
be inserted with "Loctite 648".
Insert screws and tighten to specified torque.
Note:
Ensure correct fit of gasket.