1.1 General instructions
WARNING
Before starting installation or maintenance work,
switch off the following:
•
the compressed air supply
•
the operating voltage on the fieldbus node
(pins 1 and 2)
•
the load voltage for the valves
You thereby avoid:
– uncontrolled movements of loose tubing.
– unintentional movements of the connected actuators.
– undefined switching states of the electronic
components.
CAUTION
The node of the CP system contains electrostatically
vulnerable components.
•
Do not, therefore, touch any components.
•
Please observe the regulations for dealing
with electrostatically vulnerable components.
In this way you will avoid irreparable damage to the
electronic components on the node.
General information on the installation of the CP
modules can be found in the manual "CP system".
1. Installation
CP-FB13-E 9904b 1-3
To Next Page
Loading...