Configuration with COM PROFIBUS
Prerequirements:
– the GSD must be in the directory of your PC/pro-
grammer
– the mask "Bus parameter" must be processed- bus
profile- baud rate
– the PROFIBUS address has been assigned
– the station type "FESTO CP FB13" has been se-
lected (see above)
Access the mask "Configure".Configure
1. Double click with the left-hand mouse key or single
click with the right-hand mouse key on the icon of
the Festo valve terminal.
2. Select "Configure" in the menu which appears.
The mask "Configure" will then appear (Fig. 2/8).
2. Commissioning
2-16 CP FB13-E 9904b
To Next Page
Loading...