Designated use
The CP fieldbus node CP-FB9-E documented in this
manual is designated exclusively for use as a slave on
the PROFIBUS-DP. Festo CP modules can be con-
nected to the fieldbus node CP-FB9-E. The CP node
may only be used as follows:
– as designated
– in original condition
– without unauthorized modifications
– in faultless technical condition.
The specified limit values for pressures, temperatures,
electrical data, moments, etc. must be observed when
additional commercially-available components such as
sensors and actuators are connected. Please comply
also with national and local safety laws and regulations.
Target group
This manual is directed exclusively at technicians who
are trained in control and automation technology and
who have experience in installing, commissioning, pro-
gramming and diagnosing PROFIBUS-DP slaves.
Contents and general safety instructions
CP FB13-E 9904b V
To Next Page
Loading...