1.2 Setting the DIL switches
The DIL (dual in-line) switch is situated under the cover
of the fieldbus node.
You should open and close the cover as follows:
• To open the cover, unscrew the two screws in the
cover. Remove the cover by lifting it up.
• To close the cover, replace it and tighten the screws
again by hand.
PLEASE NOTE
Tighten the screws of the switch cover only by hand.
WARNING
•
Before commissioning:
Make sure that switch elements 3..6 are set
at PROFIBUS-DP.
•
During operation:
Do not modify the setting of the DIL switches.
In this way you can avoid unintentional reactions of the
connected actuators.
1. Installation
1-4 CP FB13-E 9904b
To Next Page
Loading...