Maintenance and Troubleshooting 4-13
Document 40275-0913
Reference Flap Failure
The trigger beam is blocked or the sensor failed. Check the
trigger sensor for any blockage. Call your service department if
this message persists.
Reject Delay Too Short
Call your service department if this message persists.
Rejector Power Failure
This is a high priority message. The power to the rejector is inter-
rupted or fuse one is blown. Call your service department
immediately.
Rejector Status Is Off
This is a high priority message. An attempt was made to fire the
rejector, however the Rejector Status function is turned off. Call
your service department for assistance.
Rejector Tracker N Failure
This is a high priority message. Call your service department
immediately.
Sensor Power Failure
This is a high priority message. Power to one or more of the
sensors is failed. Call your service department immediately.
Setting Was Out Of Range
This is a high priority message. On power up, one or more of the
internal variables was out of range and the system defaults have
been loaded. Call your service department for assistance.
To Next Page
Loading...
