3.3 Drying system: what to do if. . .
The machine doesn’t dry well
1. The machine is switched off ⇒ Switch on the machine.
2. The machine doesn’t switch on ⇒ Refer to the proper section (see section
3.1 at page 10).
3. The recovery tank is full ⇒ Empty the recovery tank following
the proper procedure.
4. The vacuum motor doesn’t work
properly
⇒ Refer to the proper section (see section
3.3 at page 15).
5. The machine is set in ”ECO” Mode ⇒ Set the machine in standard Mode
by pushing again the ”ECO” button.
6. The squeegee is lifted up from the
floor
⇒ Lower down the squeegee.
7. The squeegee rubber blades are
worn out or broken
⇒ Rotate or replace the squeegee rub-
ber blades (see section 8.4.1 at page 62).
8. The squeegee is not properly ad-
justed
⇒ Adjust the squeegee properly follow-
ing the proper procedure (see section 8.3.1
at page 61).
9. The squeegee vacuum chamber is
stuck or dirty
⇒ Clean the squeegee vacuum cham-
ber.
10. The squeegee adapter is stuck or
dirty
⇒ Clean the squeegee adapter.
11. The vacuum hose is stuck or bro-
ken
⇒ Clean or replace the vacuum hose.
12. The vacuum hose is not properly
fitted in
⇒ Connect the vacuum hose properly.
13. The vacuum filter is dirty or stuck ⇒ Disassemble and clean the vacuum
filter (see section 8.4.4 at page 63).
14. The vacuum cover is not well posi-
tioned or is missing
⇒ Position properly the vacuum cover.
15. The vacuum cover gasket doesn’t
adhere properly
⇒ Replace the vacuum cover gasket.
14
To Next Page
Loading...
