3.2 Mechanical scrubbing system: what to do if. . .
The machine doesn’t clean well
1. The machine is switched off ⇒ Switch on the machine.
2. The machine doesn’t switch on ⇒ Refer to the proper section (see section
3.1 at page 10).
3. The machine is set in ”ECO” Mode ⇒ Set the machine in standard Mode
by pushing again the ”ECO” button.
4. The machine is not in working con-
dition
⇒ Switch on the machine.
Lower the scrubbing base.
Press the traction pedal.
5. The microswitch of the traction
pedal doesn’t work
⇒ Replace the traction pedal (see section
5.1.6 at page 23).
6. The brush rotates in opposite way ⇒ Check the motor connections.
7. The brush is not properly engaged ⇒ Release and engage properly the
brush.
8. The solution flow rate is not correct
or not enough
⇒ Refer to the proper section (see section
3.5 at page 17).
12
To Next Page
Loading...
