Fimap MXR - 11 Accessories; Accessories List; Blinking Kit

To Next Page

To Previous Page

Chapter 11

Accessories

11.1 Accessories List

• Blinking Kit

• Onboard Charger Kit

• Splashguard Kit

• Cleaning Accessories Kit

11.2 Blinking Kit - 222471

11.2.1 Description

The kit consists of a alarm ﬂashing yel-

low light. Although this light is not con-

sidered mandatory by law, if the user re-

quires it for their particular needs is pos-

sible to equip the machine with this ac-

cessory.

11.2.2 Installing instructions

• Unplug the power cable of the bat-

teries.

• Place the rubber circular base pro-

vided with the kit at the predisposi-

tion on the rear side of the recovery

tank near the entrance of the suc-

tion hose. Make sure the slot in the

rubber base is ﬁxed at the trimmer

guard on the recovery tank.

• Place the blinker on the rubber base

so as shown in the ﬁgure so as

to match between rubber base and

body of the blinker the three holes

for the ﬁxing screws crosswise.

11.2.2-144 11.2.2-145

• Using a Phillips screwdriver to

tighten the 3 screws supplied with

the kit, taking care to use the sili-

cone paste (red paste) previously ap-

plied on the screws.

• Remove the two screws of the brush

rear support and remove the sup-

port.

Fimap MXR - 11 Accessories; Accessories List; Blinking Kit - 222471