Operating Instructions Read Status
130 MS-9600 PN 51335:E 7/9/03
4.22.10 Annunciators
Pressing 1 while viewing Read Status Screen #4 will display the following screens:
Annunciator Screen #1 indicates if Terminal Mode, ACS Mode and UDACT options
are enabled or disabled. Pressing ‘1’ while viewing Annunciator Screen #2 allows the
operator to view the ACS Mode Annunciator addresses which have been programmed
into the control panel.
4.22.11 Phone Line
Pressing 2 while viewing Read Status Screen #4 will display the following screen:
This screen indicates the both the Primary and Secondary phone lines have been
configured for touchtone dialing operation.
READ STATUS
1=ANNUNCIATORS
2=PHONE LINES
3=CENTRAL STATION
Read Status Screen #4
ANNUNCIATORS
TERM ENABLED YES
ACS ENABLED YES
UDACT ENABLED NO
ANNUNCIATORS
1=ACS ADDRESSES
Annunciator Screen #1
Annunciator Screen #2
PHONE LINE
PRIMARY TOUCHTONE
SECONDARY TOUCHTONE
To Next Page
Loading...
