To Next Page

To Previous Page

Default Programming Correlations

148 MS-9600 PN 51335:E 7/9/03

APPENDIX B Default Programming

The following table provides a list of the programming options and their factory default settings.

Program Option Factory Default Program Option Factory Default

Detector Programming Not Installed Daylight Savings Yes

Detector Type Smoke-Photo Month Start Daylight Savings April

Detector Verification Off Week Start Daylight Savings 1st Week

Detector Walktest Yes Month End Daylight Savings October

Detector PAS No Week End Daylight Last Week

Detector Presignal No Verification No

Detector Zone Assign. 000 only (future)

Detector Adj/Noun none PAS Timer 0

Module Programming Not Installed Presignal Timer 0

Module Type Monitor Waterflow Retard Timer 0

Module Walktest Yes NAC Enable Enabled

Module PAS No NAC Silenceable Yes

Module Presignal No NAC Type Bell

Module Zone Assign. 000 only NAC Sync Type System Sensor

Module Adj/Noun none NAC Autosilence 0

Zone 0 Enable Enabled NAC Coding Steady

Zone 1 Enable Enabled NAC Zones Zone 000 only

Zone 2 Enable Enabled NAC Silence Inhibit 0

Zone 3 Enable Enabled Relay 1 Alarm

.........................through.......... ..................... Relay 2 Trouble

Zone 96 Enable Enabled Relay 3 Supervisory

Zones 97, 98 & 99 Enabled On Board DACT No

(future) Annunciator Terminal Mode No

Loop 1 & 2 Style Style 4 Annunciator ACS Mode No

Loop 1 & 2 Protocol CLIP UDACT No

Trouble Reminder Off ACS Installed No

Banner Fire•Lite Printer-PC No

Time Format 12 Hr Printer Baud 9600

Hours Setting 12 Canadian Option Off

Minutes Setting 00 Waterflow Silenceable No

Second Settings 00 (future) Off

AM-PM Setting AM

Month Setting 01

Day Setting 01

Year Setting 00

Fire-Lite MS-9600 User Manual

Other manuals for Fire-Lite MS-9600