Fire-Lite MS-9600 User Manual

Installation Optional Modules and Devices
32 MS-9600 PN 51335:E 7/9/03
2.6 Optional Modules and Devices
WARNING! Disconnect all sources of power (AC and DC) before installing or
removing any modules or wiring.
MS-9600 Keypad/Display Removal
Removal of the keypad/display is normally not necessary. If, however, it becomes
necessary to replace the keypad/display, access the auxiliary trouble bus connectors at
J16 and J17 or install the DACT-UD option module on J2, the Keypad/Display can be
removed by inserting a Phillips screwdriver into each of the three holes located in the
flexible covering of the Keypad/Display and loosening the three mounting screws.
Note that it is not necessary to disconnect the cables between the Keypad/Display and
the main circuit board unless the unit itself is being replaced. Carefully lift the Keypad/
Display and rest the unit at the bottom of the main circuit board.
+BATTERY-
LCD DISPLAY
KEYPAD I/F
1
2
3
OPT DACT
HOT
CB1
J3
J2
TB1
TB2
TB3
JP3
JP2
JP8
JP4
JP7
JP5
JP6
JP6
J17
J16
J6
J8
J7
JP10
REMOVE
TO DISABLE
LOCAL
CHARGER
DISAB LE
GND
FLT
CU T TO
MONITOR 4XTM
OPT SLC
4XTM OPT BD
TB4 TB5
TB6 TB7
TB8
NEUT EARTH
1
4
*
2
5
0
3
6
#
1
st
EV ENT ABC DEF
GHI JKL
MNO
PRS
TUV WXY
QZ
-/.
CLR
78 9
ESC
ENTER
RECALL
A
CK/STEP
ALARM
SILENCE
DRILL
HOLD 2 SEC
RESET
MODE
MAINTEN ANCE
ALARM
SILENCED
DISABLED
BATTERY
GROUND
TROUBLE
SUPERVISORY
FIRE ALARM
AC POWER
Figure 2.10 Keypad/Display Removal
Mounting Screw Access Hole
Mounting Screw Access Holes
96dact1.cdr

Fire-Lite MS-9600 Specifications

General

Brand	Fire-Lite
Model	MS-9600
Category	Control Panel
Language	English