Programming Master Programming Level
60 MS-9600 PN 51335:E 7/9/03
When the last digit is keyed-in, the following screen will be displayed:
Pressing 1 for Control Module or 2 for Monitor Module will cause the following
screen to be displayed:
The programmer can continue adding modules by pressing the ESC or left arrow
key which will return the display to the Add Module Screen #1.
3.6.2.2.2 Delete Module
Pressing 2 in the Modules Screen will display the Delete Module Screen which
allows the programmer to delete a specific module:
A flashing cursor will appear in the position of the first asterisk to the left. Using
the panel keypad, key in the module address such as 005. When the last digit is
keyed in, the following confirmation that the module has been deleted will be
displayed:
ADD MODULE
1=CONTROL
2=MONITOR
Add Module Screen #2
ADD MODULE
MODULE# 005
IS ADDED
Add Module Screen #3
MODULES
1=ADD
2=DELETE
3=EDIT
Modules Screen
DELETE MODULE
ENTER MODULE#
***
Delete Module Screen
DELETE MODULE
MODULE# 005
IS DELETED
To Next Page
Loading...
Need help?
General
