First Alert FA162C

–56–
✱
95 RING DETECTION COUNT FOR DOWNLOADING Ê ÊÊ0ÊÊ
0-15 = number of rings before control picks up phone line
Refer to the chart below and program this field accordingly.
NOTE: If "15" is
entered in field *95 to
bypass an answering
machine, and a FA4285
Phone Module is
included in the system,
you should note the
following:
When calling in from an
off-premises phone, the
user should make the
initial call, allow 1 to 3
rings only, then hang
up. The user should
then call again. The
Phone Module will now
seize the line, and 2
long tones sound,
followed by the usual
voice prompt for the 2 -
digit access code. If this
procedure is not
followed, Phone Module
operation will not be
possible.
ÊPhone Answering
Module ÊÊMachine Downloading Field
✱
95
Yes No No Set for value other than Ò0Ó (1Ð14). This
will enable the control panel to answer
the phone call. Otherwise, it will not be
possible to access the Phone Module
Yes Yes No Set for a value higher than the number of
rings for which the answering machine
is set. Example: if machine is set for 4
rings, use a value of 5 or higher. This is
recommended so that the Phone Module
can still be accessed if the answering
machine is turned off and does not
answer the phone call.
Yes No Yes Set for value other than Ò0Ó (1Ð14).
Yes Yes Yes Enter Ò15Ó to bypass answering machine.
No No No Enter Ò0Ó.
No Yes No Enter Ò0Ó.
No No Yes Enter 1Ð14.
No Yes Yes Enter 15. See note at left.
OTHER
PROGRAMMING
COMMANDS
✱
56 ZONE PROGRAMMING MODE
Interactive menu mode used for programming zone attributes and
report codes. Refer to the ZONE PROGRAMMING section for
procedure.
✱
80 OUTPUT DEVICES
Interactive menu mode applicable only if field *25 is programmed for
a 4229, 4204, or if Powerline Carrier devices are being used. Refer to
the OUTPUT DEVICES section for detailed procedure.
✱
81 ZONE LISTS FOR OUTPUT DEVICES
Interactive menu mode applicable only if *25 is programmed for a
4229, 4204, or if Powerline Carrier devices are being used. Refer to
the ZONE LIST section for detailed procedure.
✱
82 CUSTOM ALPHA EDITING
Interactive menu mode used to program zone descriptors. Refer to the
ALPHA DESCRIPTION PROGRAMMING section for procedure.
✱
83 SEQUENTIAL MODE
Interactive menu mode used to "enroll" RF transmitter serial
numbers. Refer to the SEQUENTIAL MODE section for procedure.
✱
96 INITIALIZE DOWNLOAD ID AND SUBSCRIBER ACCT. No.
FOR DOWNLOADING
Pressing *96 initializes the system for downloading.
✱
97 SET ALL PROGRAM FIELDS TO DEFAULT VALUES
Pressing
✱
97 automatically loads all defaults and erases any
information previously programmed.
✱
98 EXITS PROGRAMMING MODE
Prevents re-entry by : Installer Code + 8 + 0 + 0
Allows re-entry only by Power-up then [
✱
] and [#], unless local lockout
is enabled in field *91.
✱
99 EXITS PROGRAMMING MODE
Allows re-entry to program mode by: Installer Code + 8 + 0 + 0 or
by Power-up then [
✱
] and [#].