–69–
Adding Custom Words (will not be annunciated by FA4285 Phone Module)
You can add up to 10 installer-defined words to the built-in vocabulary. Each
of the 10 "words" can actually consist of a "word string" of one or more words,
but no more than ten characters can be used for each word or word string.
When adding Custom
Words, the keypad keys
perform the following
functions:
[4] Moves cursor one space
to the left.
[6] Moves cursor one space
to the right.
[8] Saves the new word in
the system's memory.
1. Perform steps 1, 2, and 3 of Programming the Descriptors on a
previous page.
Select CUSTOM WORD mode (enter Ò1Ó) when the prompt CUSTOM
WORD ? is displayed.
2. Enter the number ([01]Ð[10]) of the custom word or word string to be
created (for example, if you are creating the first custom word or word-
string, enter [01], for the second, enter [02], etc.). A cursor will now
appear at the beginning of the second line.
3. Refer to the CHARACTER LIST of letters, numbers, and symbols on a
following page.
Press the [#] key, followed by the two-digit entry for the first letter you
would like to display (e.g., [6][5] for "A").
The cursor will then move to the right, in position for the next character.
4. Repeat step 3 to create the desired word(s). Note that the [4] key can be
used to move the cursor to the left, if necessary. Remember, no word or
word-string can exceed 10 characters.
5. Press the [8] key to save the custom word(s) and return to the "CUSTOM
WORD ?" display.
Repeat steps 2Ð5 for other custom words to be entered. To change a
custom word, just overwrite it. If no more are to be entered now, press [0]
to return to the Descriptor entry. The custom word(s) will be
automatically added to the built-in vocabulary.
When zone descriptors are being entered as described in step 6 of
Programming the Descriptors, the custom word numbers are 245 to 254
for words 1 to 10 respectively.
To Next Page
Loading...
Need help?
General
