–78–
Ademco Contact ID Reporting takes the following format:
CCCC Q EEE GG ZZZ
where: CCCC = Customer (subscriber) ID
Q = Event qualifier, where:
E = new event , and R = restore
EEE = Event code (3 hexadecimal digits)
Note: For a complete list of event codes, refer to the
central office receiver manual.
GG = Partition Number (system messages show Ò00Ó)
ZZZ = Zone/contact ID number reporting the alarm, or user
number for open/close reports. System status
messages (AC Loss, Walk Test, etc.) contain zeroes in
the ZZZ location.
TABLE OF CONTACT ID EVENT CODES
Code Definition
110 Fire Alarm
121 Duress
122 Alarm, 24-hour Silent
123 Alarm, 24-hour Audible
131 Alarm, Perimeter
132 Alarm, Interior
134 Alarm, Entry/Exit
135 Alarm, Day/Night
143 Alarm, Expansion Module
146 Silent Burglary
150 Alarm, 24-Hour Auxiliary
301 AC Power
302 Low System Battery/Battery Test Fail
305 System Reset
333 Trouble or Tamper Expansion Module
351 Telco Line Fault
353 Long Range Radio Trouble
373 Fire Loop Trouble
Code Definition
374 Exit Error Alarm
380 Global Trouble, Trouble Day/Night
381 RF Supervision Trouble
383 RF Sensor Tamper
384 RF Sensor Low Battery
401 Disarmed, Armed AWAY (MAX),
Armed AWAY
406 Cancel by User
407 Remote Arm/Disarm (Downloading)
408 Quick Arm AWAY/MAX
441 Disarmed/Armed STAY/INSTANT , Quick Arm
STAY/INSTANT
570 Bypass
602 Periodic Test
606 AAV to follow
607 System Test
623 Event Log 80% Full
629 1-1/3 Day No Event
To Next Page
Loading...
Need help?
General
