First Alert FA162C

–90–
5881/5882 SERIES
RF RECEIVERS
(5800 System)
1. Physical: 7-3/8" (188mm) W x 4-3/8" (112mm) H x 1-7/16" (37mm) D
Note: 10-7/8" (277mm) H with antenna
2. Electrical: Voltage Input: 12VDC; Current Drain: 35mA
3. Range: 200ft (60m) nominal indoors from wireless transmitters (the
actual range to be determined with system in TEST mode).
4. Zones: (With the Ademco FA162C )
5881L/5882L: accepts up to 8 transmitters
5881M/5882M: accepts up to 16 transmitters
5881H/5882H: accepts up to 24 transmitters
5800TM
TRANSMITTER
MODULE
used with 5827BD
Wireless 2-Way Keypad
1. Physical: 2-1/4" W x 4-1/8" H x 7/8" D (57mm x 105mm x 22mm)
2. Electrical: Voltage Input: 12VDC Current Drain: 20mA
4219
WIRED EXPANSION
MODULE
1. Physical: 6-1/2" W x 4-1/4" H x 1-1/4" D (169mm x 108mm x 32mm)
2. Electrical: Voltage Input: 12VDC; Current Drain: 35mA
3. 8 EOLR Loops (AÐH): Loop A can be set for fast
(10Ð15msec)
response to an open.
4204
RELAY MODULE
1. Physical: 6-1/2" W x 4-1/4" H x 1-1/4" DÊ(169mm x 108mm x 32mm)
2. Electrical: Voltage Input: 12VDC; Current Drain: 15mA(Relays off)
180mAÊ(Relays on)
3. Four Output Relays: SPDT Contacts,
Rating: 2A max at 28VDC/AC
4229
WIRED EXPANSION/
RELAY MODULE
1. Physical: 6-1/2" W x 4-1/4" H x 1-1/4" D (169mm x 108mm x 32mm)
2. Electrical: Voltage Input: 12VDC; Current Drain: 35mA (Relays off)
100mA (Relays on)
3. 8 EOLR Loops (AÐH): Loop A can be set for fast (10Ð15msec)
response to an open.
4. Two Output Relays: SPDT Contacts, Rating: 2A max at 28VDC/AC
FA4285
PHONE MODULE
1. Physical: 6-1/2" W x 4-1/4" H x 1-1/4" D (169mm x 108mm x 32mm)
2. Electrical: Voltage Input: 12VDC Current Drain:160mA
3. Device Address: Permanently set to address 4.
4. Telephone Line Connections: See FA4285 PHONE MODULE section.