EasyGrid User Guide MAN-00084 R 11.0
3
When using any electrical appliance, basic safety precautions should be followed, including the
following:
Do not operate in wet/damp conditions.
Do not expose to outdoor conditions. Install the unit in a protective enclosure.
Do not operate in an explosive atmosphere.
Keep product surfaces clean and dry.
WARNING
This equipment must be used as specified or the protection provided by the equipment may be
compromised. You must use this product in a normal mode and should not deviate from the
written instructions provided.
CAUTION
There are no user serviceable parts inside the Nortech EasyGrid. Adjusting parts inside the unit
can affect instrument performance. If you adjust parts, you will need to verify the equipment for
good performance. Refer servicing of any other parts to qualified personnel.
3.3 Unpacking and Inspection
The EasyGrid unit is shipped inside a cardboard box designed to give maximum protection during
shipment. If the shipping box external surface is damaged, notify your shipping department immediately.
Your shipping department may want to notify the carrier.
If the shipping box is not damaged, carefully remove and identify all of the components listed below.
Contact FISO or your local representative if any of the components are missing. We recommend you save
the shipping box for future storage or transportation.
The EasyGrid package should include the following components:
Nortech EasyGrid
Power terminal wires (16 AWG)
USB interface cable
ST Optical Connector One Click Cleaner
Calibration Certificate
EasyGrid User Guide
Nortech Client software installation removable storage device
To Next Page
Loading...
Need help?
General