The surface on which the Creator Pro 2 builds an object.Build Plate
Build Tape
The three dimensional amount of space that an object will use
once it is completed. The largest build volume of Creator Pro 2
is 200*148*150mm.
The blue tape that covers Creator Pro 2’s build plate so that
the object can stick to the build plate well. Please change it
when the adhesion is not good.
Build Volume
Nuts under the platform that are used for adjusting the
distance between the nozzle and build plate.
Leveling Nuts
The device that draws the filament from the spool, melts
it and extrudes it through a nozzle onto the build plate.
Extruder
Also called“print head”, which located at the bottom of the
extruder where heated filament is squeezed out.
Nozzle
An opening located at the top of the extruder.
Filament Intake
A plastic piece that guides the filament from the filament
box to the filament intake.
Filament Guide Tube
A tool that used for seizing the nozzle’s metal cube.
Stamping Wrench
Creator Pro 2
2（independent）
Fused Filament Fabrication(FFF)
3.5’’ Touch Screen
200*148*150mm;
Mirror mode:80*148*150mm; Duplicate mode:95*148*150mm
0.1-0.4mm
±0.2mm
PLA/PVA/ABS/HIPS
1.75mm
0.4mm
10-100mm/s
FlashPrint
Input:3MF/STL/OBJ/FPP/BMP/PNG/JPG/JPEG Output:GX/G
Input:100-240VAC,47-63Hz; Power:320w
SD card，USB cable
No
Name
Number of Extruder
Print Technology
Screen
Build Volume
Layer Resolution
Build Accuracy
Print Filament
Filament Diameter
Nozzle Diameter
Print Speed
Software
Support Format
AC Input
Connectivity
Internal Storage
A tool that used for cleaning and unclogging the extruder.Unclogging Pin Tool
08
To Next Page
Loading...
