Temperature: RT 15-30℃
Moisture: 20%-70%
The device must be placed in a dry and ventilated environment. The distances of the
left, right and back side space should be at least 20cm, and the distance of the front
side space should be at least 35cm.
All polymers degrade with time. Do not unpack until filament is needed. Filament
should be stored at clean and dry conditions.
Please make sure you use the FlashForge filament or the filament from the brands
accepted by FlashForge.
All the information in this document is subject to any amendment or change without
the official authorization from FlashForge.
FLASHFORGE CORPORATION MAKES NO WARRANTY OF ANY KIND WITH REGARD TO THIS
DOCUMENT, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRATIES OF MERCHANT-
ABILITY AND FITNESS FOR A PARTICULAR PURPOSE.
Flashforge is not responsible for any safety accident caused by disassembly or
modification of equipment by the customer. FlashForge shall not be liable for errors
contained herein for incidental consequential damages in connection with furnishing,
performance or use of this material.
Flashforge reserves the right to modify the User guide due to subsequent equipment
updates.
Copyright © 2020 Zhejiang Flashforge 3D Technology Co,. Ltd All Rights Reserved
04
To Next Page
Loading...
