Flashprint - untitle.fpp
Flie(F) Edit(E) Print(P) View(V)
Print
Machine Type
FlashForge Creator Pro 2
FlashForge Creator Pro
FlashForge Creator 3
FlashForge Dreamer
FlashForge Finder
FlashForge Guider
FlashForge Guider II
Ctrl+P
Tools(T) Help(H)
Chapter 3: Slicing Software
Decompress the zipped file or start the installation program, and then install the software
according to the direction.
Start the software with the start menu shortcut by left double clicking.
There are two ways to get FlashPrint software:
Method 1：
Method 2：
To get the installation package from the SD card in the accessory kit.
Visit website www.flashforge.com, and download the latest venison in
Download Center.
30
Attention! After starting FlashPrint, you need to select the targeted machine type first.
When you start FlashPrint, a dialog box will pop up. Just need to select FlashForge
Creator Pro in the machine type list and click [OK]. You can also change the machine
type via clicking [Print]--[Machine type]. Showed the picture below:
Note：Creator Pro 2 support printing by FlashPrint with USB cable.
To Next Page
Loading...
