NOTICE
Keep your work place tidy.
Do not operate Creator Pro 2 in the presence of flammable liquids, gases or dust.
Keep Creator Pro 2 out of children and untrained persons' reach.
Always use the Creator Pro 2 with a properly grounded outlet. Do not refit Creator Pro 2
plug.
Do not use Creator Pro 2 in damp or wet locations. Do not expose Creator Pro 2 to
burning sun.
In case of device damage, please use the power supply provided by FlashForge.
Avoid using the device during an thunderstorm.
In case of uncertain accident, please unplug the power of device if you do not use it for
long.
ELECTRICAL SAFETY
Do not touch the nozzle and build plate during printing.
Do not touch the nozzle after finishing printing.
Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and
gloves away from moving parts.
Do not operate the device while you are tired or under the influence of drugs, alcohol
or medication.
PERSONAL SAFETY
Do not leave the device unattended for long.
Do not make any modifications to the device.
To lower the build plate before loading/unloading filament. (The distance between
the nozzle and build plate should be kept for at least 50mm)
Operate the device in a well-ventilated environment. Some filament may produce
odors during the printing process.
Never use the device for illegal activities.
Never use the device to make any food storage vessels.
Never use the device to make any electrical appliance.
Never put the model into your mouth.
Do not remove the models with force.
Never connect the device with network cable longer than 3m.
03
To Next Page
Loading...
