Preview： entering preview interface or not. If check the option, entering the preview
interface automatically after slicing finished. Sliding model layer number
slider on the left of interface up and down to show the model layer. The
estimated model print time and filament showed on the top right corner.
Click [Print] to connect machine; Click [Back] to back the main interface.
Materials：
Supports：
Raft：
Wall：
Brim：
Resolution：
More
options：
ABS/PLA.
When printing suspended structure models, support is necessary. Click
[Supports] to create support part for the printing.
This function will help the model to stick well on the platform.
During dual color printing, this function will help to clear the leaking
filament of another extruder.
Expand the outline of model’s bottom layers, which helps anchor the edges
of the model to the plate to avoid warping or printing fails.
You have three resolution solutions (with default setting) to choose from,
high resolution is corresponding with slow printing speed, opposite for the
low resolution. For PLA printing, an extra solution “Hyper” is available.
Click [More options] to set for layer, shell, infill, speed and temperature.
Different resolution solution is corresponding to different defaults, click
[Restore Defaults] to back to default setting.
More Options >>
Restore Defaults
Layer Height
Layer Heighe：
First Layer Height：
0.18mm
0.27mm
Shells Infill Speed Temperature Others
Layer Height: Layer thickness of the printing model. With a
smaller value, the surface of the model will be smoother.
First Layer Height: This is the first layer of the model,
which will affect the sticking performance between the
model and platform. Maximum is 0.4mm, and usually the
default is OK.
Layer Height
39
To Next Page
Loading...
