[Home]
Tap [Home] and machine come back to the zero of movement.
After stop movement of extruder and platform, tighten the three nuts below the platform
counterclockwise (To avoid scratch build plate by extruder and it is important action)
Choose one extruder and move it to the first nut by hand. Place a paper under the
extruder and tighten the nut to reduce the distance between extruder and platform.
Gently move the paper and feel the fraction. If move the paper with gent fraction, it is a
suitable distance between extruder and platform. Finished the first place, and repeat the
same actions in the second and third nut.
Homing! Please wait...
Yes Cancel Cancel
Homing Finished.
Yes
25
Screw the three nuts tnder the platform
counterclockwise until they are tight, then
tap the [Next].
Next
Please adjust the front thumb screw under
Platform when stop.
Next
Level Adjustment Finished!
Finish
To Next Page
Loading...
