FLASHFORGE 3D PRINTER CREATOR PRO 2 - Page 48

Print（Expert Mode）
I wan to：
Select Profile：
Enable Support：
Select Extruder：
General
Yes
Automatch
Preview
Restore Defaults
OK Cancel
Save As New
Remove
Save Configuration
Print When Slice Done
Creator Pro 2 PLA Standard
Speed：
Space to Model(X/Y)：
Space to Model(Z)：
Space to Raft(Z)：
Path Shape:
Path Space:
Path Angle:
Support Thickness:
Top Solid Layers:
Print Outline:
Linear
70%
0.35mm
0.20mm
0.15mm
Polyline
2.0mm
45°
70%
0
No
Speed：
Space to Model(X/Y):
Shell Count：
Lower build plate while traveling:
Treelike
60%
0.20mm
3
Yes
Perimeter Infill Raft Additions Cooling Advanced OthersGeneral Supports
The space between supports and model and support density can adjust in [supports]
setting.
46