Parking the ULW
Attention! Only park the trailer on the supporting foot when it is empty and prevent it
from rolling away.
Park the transfer trailer on level, solid ground. On soft ground, the supporting foot's
surface area must be increased by using a suitable aid (e.g. a wood plank).
Extend the hydraulic supporting foot. Lower the mechanical supporting stand and
secure it.
When parking the trailer, the drive shaft must be deposited correctly or secured with a
chain.
Handling the mech. supporting stand
Couple the ULW to the tractor (coupling height can be adjusted slightly via the hydr.
ULW drawbar suspension).
Take the load off the supporting foot by operating the hydr. drawbar suspension.
Remove the locking pin (by swivelling), push the supporting foot up and lock it in place.
Ensure that the pin is secured correctly.
Move the supporting foot down and lock it again. Lower the trailer again via the hydr.
drawbar suspension.
Disconnect the hydraulic and electrical lines and uncouple the vehicle.
The tractor is a weight-bearing element for single-axle and tandem trailers. Therefore, the
trailer must only be set down on the supporting foot when it is empty.
To Next Page
Loading...
