Fliegl ULW - Tyres and Wheels

ULW transfer trailer
Service and maintenance
Fliegl Agrartechnik GmbH, 84453 Mühldorf am Inn, Germany
64 of 85
Other lubricating points
Centre bearing ULW 30
The centre bearing must be checked for wear and lubricated every 200 operating hours or annually.
Inclined screw conveyor
The overhead loading screw is mounted in sintered metal bushings.
These should be lubricated with a few drops of transmission oil every 3 months.
Lubricating the drive chain of the longitudinal screw conveyor
- Release and unscrew the mounting bolts on the cover.
- Remove old grease from the drive chains and chain pinions.
- Apply new grease to the chains and pinions with a brush.
- Refit the cover.
10.4.5 Tyres and wheels
Check and adjust the tyre pressure every 3 months on cold tyres based on the following table:
Dimension
Load index
Tyre pressure [bar]
28 L 26
16 PR
2.20
550/60-22.5
16 PR
3.80
560/60-R22.5
Radial
4.00
600/55-26.5
16 PR
2.40
650/55-R26.5
Radial
4.00
710/50-R26.5
172D
3.60
850/50-R30.5
16 PR
3.60
The numbers in the table may differ depending on the tyre manufacturer.
Not all tyres are suitable for speeds > 40 km/h.
See also: Equipment and technical data for the load capacity values of the
individual ULW models.
Use a torque wrench to tighten the wheel nuts crosswise according to the table below.
Thread
Tightening torque (max.)
M18 x 1.5
290 Nm
M20 x 1.5
380 Nm
M22 x 1.5
510 Nm
For more information, refer to section 13.2.