Fliegl Agrartechnik GmbH, 84453 Mühldorf am Inn, Germany
10.6 Decommissioning
10.6.1 Temporary shutdown
Switch off the machine and all attached assemblies, disconnect the machine; see section 7.1.6. Clean
and maintain the machine (see section 10.4).
After a temporary shutdown, a new start-up must take place. See also section 5.3.
10.6.2 Storage conditions
For short and medium periods (up to 2 years), the machine can be stored without special measures in
the ambient conditions specified in the technical data.
For long-term storage, measures must be taken to prevent corrosion:
1. Clean the entire transfer trailer thoroughly inside and out, then leave the transfer trailer to
dry.
2. Spray the entire trailer inside and out with a film of oil.
3. Store the Fliegl trailer in a dry, clean and rust-free place.
4. We recommend covering the trailer with a tarpaulin to protect it against dust etc.
5. Deactivate the pneumatic, hydraulic and electrical supplies to the machine. Protect
connections.
6. Lubricate the Fliegl transfer trailer (see lubrication schedule).
7. Thoroughly grease bare piston rods and retract them.
10.6.3 Disassembly and final shutdown
1. Switch off the machine.
2. Disconnect the power line from the switch cabinet or disconnect the plugs, roll up the
supply line cable and secure it on the machine.
3. Turn off the compressed air supply and disconnect the supply line.
4. Drain the auxiliary materials.
5. Disassembly of the machine is performed in the reverse order to assembly, or as
described in the disassembly instructions.
10.6.4 Scrapping and recycling
Separate machine parts and electrical parts and dispose of them in the correct manner.
Separate all parts, auxiliary materials and working materials of the machine and
dispose of them according to local regulations and directives.
If you have any questions about scrapping/recycling, please contact the
manufacturer.
To Next Page
Loading...
