Fliegl ULW - Service and Maintenance

ULW transfer trailer
Service and maintenance
Fliegl Agrartechnik GmbH, 84453 Mühldorf am Inn, Germany
63 of 85
10.4.4 Lubrication
Lubricants to use:
Lubricants
Type
Quality
Oils
Hydraulic oil
HLP 68
Greases
Lithium grease
DIN 51 502, KP 2K
There is a risk of injury due to rotating and movable parts when lubricating. When
lubricating the towing vehicle engine, apply the parking brake and remove the ignition
key.
Lubricating the drive shafts:
The drive shafts must be lubricated at the
specified points every 50 operating hours.
Fig. 66: Lubricating points
Lubrication schedule
The lubrication schedule applies to all Fliegl transfer trailers.
Dispose of old oil and grease in the correct manner.
Every 8 op. hrs.
Every 50 op. hrs.
Every 100 op. hrs.
Every 500 op. hrs.
- Ratchet clutch
- Drive shaft bearing
- Shaft bearing
- Transmission bearing
- Parking brake
(on pneumatically operated
trailers)
- Brake linkage
- Spring bolts
- Centre bearings
- Pivot point of steered
trailing axle
- Wheel hub
bearings
Lubricating points on transfer trailer
Lubricating points with lubricating
nipples
Lubricating points without lubricating
nipples
Mounting of the brake camshaft
Actuating device of the parking brake
Mounting of the slack adjusters
Brake rod
Mounting of the PTO
Spring bolts
Cardan joints of the drive shafts
All other movable parts on the chassis and body
Bearings on the screw conveyors
Bearings on the splined shafts