M400 Web Browser Interface
432-0012-00-12 Version 110 July 2016 34
Maintenance->Sensor->Devices->Pan & Tilt
Startup Mode
Select an action the camera will perform at startup (power cycle or server reset).
Configure Ball Down Installation
The camera is configured for Ball Down or Ball Up operation with a single menu control.
1. On the Maintenance->Sensor->Devices->Pan & Tilt page, set Upside Down to Yes.
2. Scroll down and select Save.
3. Stop and start the server to make the change effective.
Scroll down
to Save
Select an action
from the menu
Select Yes
for Ball Down
installation
Stop and start the server
Scroll down
to Save
Select Yes
for Ball Down
Stop and start the server
To Next Page
Loading...
